Dynalink RTA1030W Manual de usuario descargar pdf (Pagina 94)

Chapter 4: Web Configuration

Advanced Setup

Local Network – IP Address

This page is the same as you can see on the Configure LAN side Settings page

while running the Quick Setup. It allows you to set IP Address and Subnet Mask

values for LAN interface.

Primary IP Address:

Key in the first IP address that you

received from your ISP for the LAN

connection.

Subnet Mask:

Key in the subnet mask that you

received from your ISP for the LAN

connection.

Host Name:

List the host name of this device.

Domain Name:

List the name of the domain.

Configure the secondary IP

Address and Subnet Mask:

Check this box to enter another set of

IP Address and Subnet Mask to

connect to your router if they are not

included in the range that DHCP

server accepts.

After checking this box, the secondary

IP address and subnet mask entries

will show up, as shown in the right

figure. Enter the information provided

by your ISP for your LAN connection.

MTU:

It means the maximum size of the

packet that transmitted in the network.

The packet of the data greater than

the number set here will be divided

into several packets for transmitting.

Type the value into the field of MTU.

The default setting for LAN is 1500.

Apply:

Click this button to activate the

settings listed above.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 146 147

Sin comentarios

Dynalink RTA1030W Manual de usuario Pagina 94